3 Lines from Breather

ColbyL

Need a little help. I am removing my old carb from my 1988 Mazda B2200 (Base) model and replacing with a Weber. There are 3 rubber hoses that come out of the front of the breather and connect to metal lines running back toward the rear of the engine. What do you guys recommend doing with those 3 lines? Photos would be great if you have available. Thanks!!

Cusser

You can plug those little rubber hoses with rubber stoppers from the hardware store, use the same clamps.
I used 14mm x 1.5mm capped wheel lugs from O'Reillys to plug the pair tube outlets coming out the upper manifold heat shield. You can remove the other two steel lines and block them off, which is what I eventually did on mine. I had to make a metal block-off.

MazdaMitch

Optimal thing to do would be to get a header.

Other than that you can unbolt that and take it out and cut the piping and cramp the absolute shit out of it and put it back on.

Or you can create yourself a little block off plate and put that back on.

Zoom in on this photo you'll see what I'm talking about it's cramped.

ColbyL

Thanks Cusser and MazdaMitch for the help and quick response, definitely going to try this out tomorrow.